745619 Removing and installing lock for load-through system

WM 745619 Removing and installing lock for load-through system

Technical values





Removing lock for load-through system





Installation position of lock for load-through system

1. Fold the load-through system over.
2. Unscrew fastening screw -1- on the cover -arrow A-.
3. Unclip and remove the cover -arrow B-.





Unscrewing fastening screw on cover

4. Unscrew fastening screws on the lock.

Information

Make sure that the two spacer sleeves do not fall in between the backrest frame and cushion during removal and installation.

5. Remove the two spacer sleeves -2-.





Unscrewing fastening screws on lock

6. Release and disconnect the cable -a-.





Disconnecting cable

7. Remove the lock.

Installing lock for load-through system

1. Insert the cable into the lock and lock it -a-.





Inserting cable

Information

Make sure that the two spacer sleeves do not fall in between the backrest frame and cushion during removal and installation.

2. Position the lock and the two spacer sleeves -2- on the backrest frame.
3. Screw in fastening screws on the lock and tighten to the specified tightening torque.=> Tightening torque: 20 Nm (15 ftlb.)+/-2 Nm (+/-1.5 ftlb.)





Tightening fastening screws on lock

4. Clip in the cover -arrow C-.
5. Screw in fastening screw -1- on the cover -arrow D-.





Screwing in fastening screw on cover