Engine Mounting

Removing and installing engine mounting

Information

Component overview

Left engine mounting





Left bracket for auxiliary units and 2WD engine mounting

1 - Bracket for auxiliary units
2 - Screw, M10 x 45
3 - Dowel sleeve
4 - Engine carrier
5 - Hydraulic mount, left
6 - M12 nut

Right engine mounting





Right engine mounting

1 - Engine carrier
2 - Screw, M10 x 45
3 - Nut, M12 x 1.5
4 - Hydraulic mount, right
5 - Installation view of screw-on points for engine carrier on crankcase

Left engine mounting, 4WD





Left bracket for auxiliary units and 4WD engine mounting

1 - Bracket for auxiliary units
2 - Screw, M10 x 45
3 - Dowel sleeve
4 - Engine carrier/cross-shaft engine carrier
5 - Hydraulic mount, left
6 - M12 nut

Preliminary work

1. Remove the front-axle carrier.

Removing engine mounting

Removing right engine mounting

WARNING
Danger of objects or loads falling down
* Risk of squashing or crushing

-> Secure components to prevent them from falling down.

1. Press against the engine mounting from below and loosen the fastening nuts on the engine mounting.





Loosen the engine mounting (figure shows 4WD Turbo).

2. Remove the engine mounting and nuts from the guide.





Removing engine mounting (figure shows 4WD Turbo)

Removing left engine mounting

1. Press against the engine mounting from below and loosen the fastening nuts on the engine mounting.





Loosen the engine mounting (figure shows 4WD Turbo).

2. Remove the engine mounting and nuts from the guide.





Removing engine mounting (figure shows 4WD Turbo)

Installing engine mounting

Installing engine mounting at the left and right

Information
The tightening specifications for the basic engine are stored centrally. Tightening torques and assembly instructions for other affected assemblies (e.g. chassis, electrics, transmission or body) or for peripheral engine equipment can be found in the corresponding documents.

1. Guide engine mounting into the receptacle provided for it.
2. Guide the engine mounting guide pin into the groove provided for it so that it can no longer pop out.





Guide pin

3. Press against the engine mounting from below and tighten the fastening nuts on the engine mounting.

Subsequent work

1. Install the front-axle carrier.