Garage Door Opener Transmitter: Description and Operation

Home Link







The Panamera features a Home Link system that actuates the garage door drive, gate to property, alarm system or door locking. The programmed function is activated by pressing the relevant button in the keypad of the roof console. The garage door opener used in North America assigned frequency range 288 MHz - 418 MHz.

Deleting Programmed Signals From The Buttons







This process deletes the standard factory-set codes. Do not repeat this process if you want to assign additional signals to the buttons. Keep the two outer buttons (arrows in above illustration) on the overhead operating console pressed down for approx. 20 seconds until indicator light A on the button begins to flash quickly.

To delete the programmed signals and save garage door opener signals, the ignition must be switched on and the direction indicators switched off. When using the garage door opener, the vehicle must be in range of the receiver.

Assigning Home Link to Button With Fixed Code System

1. The standard factory-set codes must be deleted before programming for the first time.
2. Keep the required button pressed down in the keypad on the overhead operating console until indicator light A on the button begins to flash slowly. The button is now ready to learn for five minutes.







3. Hold the original hand-held transmitter approx. 30 cm from the marked position and keep the send button pressed down until the vehicle's direction indicator lights light up three time or indicator light A flashes quickly. Three flashes of the direction indicator lights and the rapidly flashing indicator light A confirm that the new signal has been programmed successfully. A number of attempts may be necessary at different distances between the vehicle and the original handheld transmitter.
4. Once the five-minute learning period has expired, the direction indicator lights flash once. Repeat steps 2 and 3.
5. Repeat steps 2 to 4 to assign signals to the other buttons.

Assigning Home Link to Button With Variable Code System
1. The standard factory-set codes must be deleted before programming for the first time.
2. Keep the required button pressed down in the keypad on the overhead operating console until indicator light A on the button begins to flash slowly. The button is now ready to learn for five minutes.







3. Hold the original hand-held transmitter approx. 30 cm in front of the bumper and keep the send button pressed down until the vehicle's direction indicator lights light up three time or indicator light A flashes quickly. Three flashes of the direction indicator lights and the rapidly flashing indicator light A confirm that the new signal has been programmed successfully. A number of attempts may be necessary at different distances between the vehicle and the original hand-held transmitter.
4. To synchronize the system: Press the programming button on the receiver for the garage door opener. Afterwards, you usually have approx. 30 seconds to initiate step 5.
5. Press the button in the keypad of the overhead operating console selected in step 2 (with some devices, you need to press the button in the keypad several times in order to complete the setting process).
6. Repeat steps 2 to 5 to assign signals to the other buttons.

To Reprogram a Single Button
1. Keep the button to be programmed in the keypad of the overhead operating console pressed down (approx. 20 seconds) until indicator light A on the button flashes slowly. The button is now ready to learn for five minutes.







2. Hold the original hand-held transmitter approx. 30 cm from the marked position and keep the send button pressed down until the vehicle's direction indicator lights light up three time or indicator light A flashes quickly. Three flashes of the direction indicator lights and the rapidly flashing indicator light A confirm that the new signal has been programmed successfully. A number of attempts may be necessary at different distances between the vehicle and the original handheld transmitter.