Removing and Installing Switch Console

Removing And Installing Switch Console

Tools







Preliminary work
1. If a new control unit has to be installed, the values/coding must be read out using the 2nd generation PIWIS Tester 9818 prior to removing the "old" DME control unit.
2. Remove lower part of centre console cover.

Removing switch console

INFORMATION: The number of plug connections can vary, depending on equipment.







1. Switch off ignition and remove remote control.
2. Unscrew the two fastening screws -1-.







3. Unclip and lift switch console.







4. Release plug connections -2- and -3- ( -a- ) and pull them off -B-.







5. Release plug connection -4- ( -a- ) and pull it off -B-.







6. Release plug connection -5- ( -a- ) and pull it off -B-.







Installing switch console

1. Connect plug connection -5- until it engages securely.







2. Connect plug connection -4- until it engages securely.







3. Connect plug connections -2- and -3- until they engage securely.







4. Insert and clip in switch console.







5. Screw in the two fastening screws -1-.







Subsequent work
1. If the control unit was replaced, the "new" control unit must be adapted to suit the vehicle using the 2nd generation PIWIS Tester 9818.
2. Install lower part of centre console cover.