97321905 Removing and installing wire harness for door in rear door sub-frame

WM 973219 Removing and installing wire harness for door in rear door sub-frame

Information

Component information - rear door





Installation position of wire harness for rear door





Preliminary work

Preliminary work for rear door sub-frame

1. Remove rear door sub-frame. -> 583019 Removing and installing rear door sub-frame - section on "Removing" 583019 Removing and Installing Rear Door Sub-frame

Removing wire harness for door in rear door sub-frame

Information

The number of plug connections can vary, depending on equipment.

1. Disconnect electric plug connections.
1.1. Release electric plug connection for door wire harness at the door control unit -a- and pull it off -B-.





Disconnecting electric plug connection

1.2. Release electric plug connection -4- for door wire harness at the door control unit -a- and pull it off -B-.





Disconnecting plug connection

1.3. Release electric plug connection for power windows motor -a- and pull it off -B-.





Pulling off connector on power windows motor

1.4. Release electric plug connection for woofer -a- and pull it off -B-.





Pulling off connector on woofer

2. Unclip fixing clips for wire harness at the inside.





Removing inner fixing clips

3. Press rubber sleeves out of the opening in the door sub-frame.





Removing rubber sleeves

4. Guide wire harness out of the door sub-frame.

Installing wire harness for door in rear door sub-frame

Information

The number of plug connections can vary, depending on equipment.

1. Guide wire harness into the door sub-frame.
2. Clip in wire harness at the door sub-frame.





Clipping in wire harness

3. Press rubber sleeves into the opening in the door sub-frame. Check that they are seated securely.





Securing rubber sleeves

4. Plug in electric plug connections.
4.1. Plug in electric plug connection for woofer until it engages securely.





Plugging in connector for woofer

4.2. Plug in electric plug connection for power windows motor until it engages securely.





Plugging in connector on power windows motor

5. Plug in electric plug connections on the door control unit.





Plugging in connectors on door control unit

5.1. Clip electric plug connection into the bracket -A-.
5.2. Plug in electric plug connection on the door control unit -B- and -C- until it engages securely.
5.3. Plug in and lock electric plug connection on the door control unit -D-.

Subsequent work

Subsequent work for rear door sub-frame

1. Install rear door sub-frame. -> 583019 Removing and installing rear door sub-frame - section on "Installing" 583019 Removing and Installing Rear Door Sub-frame