2X00IN Battery trickle charging

WM 2X00IN Battery trickle charging

Information

Battery trickle charging

=> Workshop Equipment and Special Tools Manual Battery chargers.

Information

- When working or carrying out tests on the vehicle or when the vehicle is in the workshop, a battery charger with a rated current of at least 40 A must be connected.

- As soon as the vehicle is unlocked, e.g. the vehicle is in the workshop or salesroom, it must be trickle charged with a battery charging device.

NOTICE

Using charging cables/jump leads directly on the vehicle battery.

- Risk of damage to battery sensors.

-> Always connect charging cables/jump leads to the external power supply for jump-lead starting.

1. Open protective cover on the positive terminal for jump-lead starting -+- ( -arrow- ).





Protective cover on positive terminal for jump-lead starting

2. First, connect the positive cable from the charger to the positive terminal -+-.
3. Then connect the negative cable from the charger to the ground point for jump lead starting ---.
4. Read operating instructions for the charger.
5. Switch off all loads.
6. Switch on the charger.

Connecting the battery for trickle charging

A suitable battery charging device must be connected to the vehicle electrical system when performing the following tasks. All unnecessary loads must be switched off.

When working on the vehicle for more than 15 minutes

When running a diagnosis using the Porsche System Tester

When adjusting the headlights

When working on or with the Infotainment system

If the doors, bonnet and rear lid are open for a long period of time or if these components are actuated frequently