Door Lamp: Service and Repair

WM 961619 Removing and installing door warning light

Removing door warning light

Information

- The work steps are described for the left rear door of the vehicle and must be performed in the same way on the other doors. Any different work steps are marked/highlighted.





Door warning light arrangement

1. Unclip the door warning light -A- and remove it -B-.





Removing door warning light

2. Pull off connector.





Pulling off connector

Installing door warning light

Information

- The work steps are described for the left rear door of the vehicle and must be performed in the same way on the other doors. Any different work steps are marked/highlighted.

1. Connect connector.





Plugging in connectors

2. Check that the connector is seated securely.
3. Fit the door warning light -A- and clip it in -B-.





Installing door warning light

Replacing bulb for door warning light

NOTICE

Incorrect handling of bulbs

- Risk of damage to bulbs and the bulb housing

-> Switch off ignition and remove ignition key.
-> Switch off the relevant loads when changing bulbs.
-> Only use bulbs listed in the bulb table.
-> Only install clean bulbs that are free of grease.
-> Always use a cloth or soft paper when working with bulbs.
-> Observe the safety instructions when changing a bulb in a Bi-Xenon headlight.
-> In certain states, it is compulsory to carry spare light bulbs.

1. Remove door warning light.
2. Turn the holder to release it.





Releasing holder

3. Pull holder out of the door warning light.





Removing holder

4. Pull the bulb out of the holder.
5. Insert a new bulb into the holder.
6. Guide the holder into the door warning light.





Guiding in holder

7. Turn the holder to lock it.





Locking holder

8. Install door warning light.