430501 Checking fluid level (PDCC)

WM 430501 Checking fluid level (PDCC)

Checking fluid level

NOTICE

Aggressive fluids

- Risk of damage to components and surfaces

-> Do not spill fluids.
-> In the event of contact, wash the component or surface with water.
-> Replace components that are already damaged.

WARNING

Caustic fluids

- Danger of chemical burns

-> Avoid contact with caustic fluid.
-> Wear personal protective gear.
-> Ensure that there is good ventilation.
-> If you do come into contact, wash off immediately with plenty of warm water and contact a doctor if necessary.

Information

Overfilling the system can cause Pentosin CHF 202 to overflow onto coolant hoses and other components. The engine must be run for approx. 20 seconds prior to the fluid level check. Check the fluid level.

1. Open the front lid.
2. Unscrew reservoir cap.
3. The cap has a dipstick with a -MIN/MAX marking-. The fluid level must be between the two markings when the engine is stopped and cold (approx. 20 °C).





Markings on dipstick

4. Fluid level below -MIN- :
4.1. Fill the reservoir with Pentosin CHF 202.
4.2. Check the fluid level again.
4.3. Top it up again if necessary until the fluid level is between the two markings.
5. Fluid level above -MAX- :
5.1. Remove fluid using a clean fluid extractor.
5.2. Check the fluid level again.
5.3. Repeat the process until the fluid level is between the markings.
6. Close the front lid.