91381900 Removing and installing rod antenna

WM 913819 Removing and installing rod antenna

Technical values





Preliminary work

1. Remove rear part of right front wheel housing liner => 505619 Removing and installing front wheel housing liner - section on "Removing".
2. Remove carbon canister. => 202519 Removing and installing carbon canister - section on "Removing"

Removing rod antenna





Installation location for rod antenna





Rod antenna installation location for the 911 Cabriolet

CAUTION

Voltage peaks can damage the audio system.

-> Before unplugging/removing audio components, remove ignition key and switch off audio system.

1. Remove the ignition key and switch off the audio system.
2. Unscrew antenna rod on the antenna base cover.
3. Unscrew fastening nut -B- and remove antenna base cover -A-.





Antenna base cover

4. Remove -arrow- seal.
5. Take out antenna base downward and pull off both connectors -A and B- from the antenna base.





Antenna base connector

Installing rod antenna

1. Push both connectors -A and B- onto the antenna base until they are felt to engage.





Antenna base connector

2. Insert antenna base in the cut-out from below. The bar of the antenna base must be inserted in the guide nut -A- while doing so.





Inserting the antenna base

3. Insert seal with the locating pins -A- in the holes -B- on the antenna base cover.





Inserting the seal on the antenna base cover

Information

The seal (arrow) must make contact all the way around on the antenna base cover.

4. Position antenna base cover -A- and tighten the fastening nut -B-. => Tightening torque: 3 Nm (2 ftlb.)





Antenna base cover

5. Screw in antenna rod hand-tight in the antenna base cover.

Reworking

Subsequent work

1. Install carbon canister. => 202519 Removing and installing carbon canister - section on "Installing"
2. Install rear section of front right wheel housing liner=> 505619 Removing and installing front wheel housing liner - section on "Installing"