707519 Removing and installing rear side trim panel

WM 707519 Removing and installing rear side trim panel

Technical values





Preliminary work

1. Remove rear loudspeaker. => 914219 Removing and installing rear loudspeaker - section on "Removing"

Removing rear side trim panel

Loosening seat belt and fitting

1. Lever off cap -1- with a screwdriver -arrow-.





Removing seat belt and fitting

2. Unscrew fastening screw -2-. Remove washer -3- , seat belt mount -4- and spacer sleeve -5-.

Removing cover of three-point seat belt





Installation position for side trim panel

1. Pull cover of three-point seat belt -1- forwards out of the clips -2-.





Removing cover of three-point seat belt

Removing side panel trim at rear

1. Pull off door seal at side trim panel.
2. Unscrew fastening screw -1- at side trim panel -2- ( -arrow- ).





Fastening screw at front side trim panel

3. Unscrew fastening screw -1- on side trim panel -2- close to the loudspeaker -arrow-.





Removing fastening screw close to loudspeaker

4. Move backrest forward.
5. Unscrew locking pin -1- for backrest. Remove locking pin and washer -2- ( -arrow- ).





Removing backrest locking pin

6. Carefully unclip side trim panel and pull inwards to remove it -arrow-.





Removing side trim panel

Installing rear side trim panel

1. Place side trim panel into position from inside -arrow- and clip in carefully.





Installing side trim panel

2. Insert locking pin -1- with washer -2- ( -arrow- ).
Screw in locking pin for backrest. Tightening torque => Tightening torque: 35 Nm (26 ftlb.)+2 Nm (+1.5 ftlb.)





Installing backrest locking pin

3. Move backrest back into sitting position again.
4. Insert fastening screw -1- on side trim panel -2- close to the loudspeaker -arrow- and screw down securely.





Screwing in fastening screw close to loudspeaker

5. Insert fastening screw -1- from above -arrow- at side trim panel -2- and screw in securely. Tightening torque => Tightening torque: 0.6 Nm (0.5 ftlb.)





Tightening fastening screw on side trim panel

6. Attach door seal at side trim panel.

Installing cover of three-point seat belt

1. Check clamps -2- for damage, replacing if necessary. Press in cover of three-point seat belt -1- into the clamps with the locking tabs until these lock with an audible click.





Installing cover of three-point seat belt

Securing seat belt and fitting

Information

Ensure that belt strap can run properly!

1. Secure fastening screw -2- , washer -3- , seat belt with fitting -4- and spacer sleeve -5- on the body. => Tightening torque: 50 Nm (37 ftlb.)+/-10 %





Securing seat belt and fitting

2. Press cap -1- onto the fastening screw -2- ( -arrow- ).

Subsequent work

1. Install rear speaker. => 914219 Removing and installing rear loudspeaker - section on "Installing"