611719 Removing and installing hardtop fastening

WM 611719 Removing and installing hardtop fastening

Technical values





Preliminary work

Remove cover for the rear. -> 705319 Removing and installing cover for rear- section on "Removing" 705319 Removing and installing rear cover.

Removing hardtop fastening

Removing bracket for hardtop mount





Installation position of bracket for hardtop mount

Information

Only when removing the left bracket for hardtop mount.

1. Press in locking tabs -Arrows A- and pull electric plug connection -1- up and off -Arrow B-.





Removing bracket for hardtop mount

2. Unscrew fastening screws -2- inside and remove the retaining angle -3-.
3. Unscrew fastening screws -2- outside and remove bracket for hardtop mount -4- upwards out of the frame of roll-over protection system -5-.

Installing hardtop fastening

Installing bracket for hardtop mount





Installation position of bracket for hardtop mount

1. Position bracket for hardtop mount -4- on frame for roll-over protection system -5- and screw down the fastening screws -2- on the outside. Tightening torque => Tightening torque: 9.7 Nm (7.2 ftlb.)





Installing bracket for hardtop mount

2. Position retaining angle -3- on frame for roll-over protection system -5- and screw down with the fastening screws -2- on the inside. Tightening torque => Tightening torque: 9.7 Nm (7.2 ftlb.)

Information

Only when removing the left bracket for hardtop mount.

3. Press in electric plug connection -1- until it audibly engages.

Subsequent work

Install cover for rear. -> 705319 Removing and installing cover for rear- section on "Installing" 705319 Removing and installing rear cover.