Intake Manifold - X51
WM 244719 Removing and installing intake manifold - X51
(cylinder bank 1-3)
Intake manifold and insert six outer Torx screws in even sequence.
Tighten the screws.
Tightening torque: 13 Nm (9.5 ftlb).
Fasten lateral bracket -1- for wire harness with two M6 x 12 external Torx screws (E10) -2-.
Tighten the screws.
Tightening torque: 10 Nm (7.4 ftlb).
(cylinder bank 4-6)
Intake manifold and fit six outer Torx screws in sequence.
Tighten the screws.
Tightening torque: 13 Nm (9.5 ftlb).
Intake manifold, cylinder bank 4-6
Fasten wire harness with new tie-wrap -1-.
Fasten wire harness with tie-wrap (bank 4-6 shown).
Fasten lateral bracket -1- for wire harness with two M6 x 12 external Torx screws (E10) -2-.
Tighten the screws.
Tightening torque: 10 Nm (7.4 ftlb).