705319 Removing and installing rear cover.

WM 705319 Removing and installing rear cover.

Preliminary work

1. Remove trim panel for hood compartment. => 700819 Removing and installing trim panel for hood compartment - section on "Removing"

Removing rear cover





Installation location for rear cover

1. Using a plastic wedge between the cover for rear -1- and cap, move in roll-over protection -2- , take off roll-over protection cap up and out in -direction of arrow-.





Removing roll-over protection cap

2. Loosen fastening screws -2- and pull cover for rear -1- up and out.





Removing cover for rear

Installing rear cover





Installation location for rear cover

1. Position cover for rear -1- on frame for roll-over protection system -3- and screw down the fastening screws -2-.





Installing cover for rear

2. Position cap for roll-over protection -2- on the cover for rear -1- and press in in -direction of arrow-.





Installing roll-over protection cap

Subsequent work

Install trim panel for convertible top rest. => 700819 Removing and installing trim panel for convertible top rest - section on "Installing"