34352750 Removing and mounting transmission

WM 343527 Removing and mounting transmission

Technical values





Preliminary work

1. Remove engine-transmission unit. => 100119 Removing and installing engine - section on "Removing"

Removing transmission

1. Unclip coolant lines from the holders.





Coolant lines

2. Remove cable duct. To do this, unscrew the screws and move the cable duct towards the engine.





Cable duct

3. Attach transmission to workshop crane.

NOTICE

Mechanical overload of components

- Component will be damaged irreparably

-> Observe guidelines for assembly and disassembly

Information

When you loosen the flange screws between the transmission and engine, the screws -1 and 2- must first be loosened and unscrewed. If this is not done, the engine housing can be damaged irreparably.





Flange screws

4. Unscrew the two bottom fastening screws between the engine and transmission.
5. Unscrew the remaining fastening screws.
6. Remove the transmission by guiding it towards the rear.

Mounting transmission

1. Attach transmission to workshop crane.
2. Run in transmission.

NOTICE

Mechanical overload of components

- Component will be damaged irreparably

-> Observe guidelines for assembly and disassembly

Information

Always replace flange screws.

When you screw in and tighten the flange screws between the transmission and engine, the screws -1 and 2- must be screwed in and tightened last. If this is not done, the engine housing can be damaged irreparably.





Flange screws

3. Screw in and tighten the four top fastening screws.






4. Screw in and tighten the two bottom fastening screws.






5. Fit cable duct.





Cable duct





6. Engage coolant lines in holder.





Coolant lines

7. Adjust the shift and selector cables after installing the transmission. See "Securing selector cable". => 341219 Removing and installing shift and selector cables