60351900 Removing and installing powered sunroof mechanism

WM 603519 Removing and installing powered sunroof mechanism

Preliminary work

1. Remove sliding roof. -> 600519 Removing and installing sunroof - section on "Removing" 60051900 Removing and installing sunroof
2. Remove sliding-roof panel. -> 604019 Removing and installing sliding-roof panel - section on "Removing" Service and Repair
3. Remove motor for sliding roof. -> 601419 Removing and installing motor for sliding roof - section on "Removing" 601419 Removing and installing motor for sliding roof

Removing powered sunroof mechanism

Information

Some of the repair illustrations show only one side of the vehicle. Naturally, some steps also have to be performed on the opposite side of the vehicle as well. These must be carried out as a mirror image of the steps shown.

1. Unclip end pieces -1- and pull them off the frame.





Unclipping end pieces

2. Pull the sliding sun screen back out of the frame.





Removing sliding sun screen

3. Pull the powered sunroof mechanism evenly to the rear on both sides -A-.





Removing water drain strip

4. Unclip water drain strip -3- ( -B- ).
5. Pull the powered sunroof mechanism and drive cables completely out of the frame.

Installing powered sunroof mechanism

Information

Some of the repair illustrations show only one side of the vehicle. Naturally, some steps also have to be performed on the opposite side of the vehicle as well. These must be carried out as a mirror image of the steps shown.

1. Clean the frame if you intend to use it again.
1.1. Remove sealing material and clean sealing surfaces.
1.2. Clean the guides -1,2,3,4-.





Guide

2. Grease the frame and powered sunroof mechanism.
2.1. Grease the guides -1,2,3,4- with => GREASE.
2.2. Grease sliding pieces on the powered sunroof mechanism with => GREASE.
2.3. Grease sliding track on the front and rear powered sunroof mechanism -5- with => GREASE.





Greasing sliding track

3. Carefully guide the drive cable into the frame without kinking it.
4. Guide the powered sunroof mechanism into the frame.
5. Clip in the water drain strip -3- ( -A- ) and slide in the guide -B-.





Installing water drain strip

6. Position the powered sunroof mechanism.





Positioning powered sunroof mechanism

6.1. Slide the powered sunroof mechanism forward as far as it will go.
6.2. Slide the slide for the powered sunroof mechanism -6- forward until the guide screw -7- is over the marking -8-.
The front edge of the slide -6- must also be between the two notches.
6.3. Set the same position on both sides.
7. Install end pieces.
7.1. Apply sealing compound -9- => SEALING COMPOUND to the new end pieces.





Applying sealing compound

7.2. Fit the end pieces at the outside first and then clip them in -1-.





Clipping in end pieces

7.3. Press the end pieces gently onto the frame and remove any excess sealing compound.

Subsequent work

1. Install motor for sliding roof. -> 601419 Removing and installing motor for sliding roof - section on "Installing" 601419 Removing and installing motor for sliding roof
2. Check the position of the powered sunroof mechanism.





Positioning powered sunroof mechanism

3. Install sliding-roof panel. -> 604019 Removing and installing sliding-roof panel - section on "Installing" Service and Repair
4. Install the sunroof. -> 600519 Removing and installing sunroof - section on "Installing" 60051900 Removing and installing sunroof