600625 Programming/teaching Roof Assembly (panorama Roof)

WM 6006AN Teaching roof systems

Teaching roof system end position

Teaching roof system end position

Information

The end positions of the slide/tilt sunroof or panorama roof will be lost after disconnecting/connecting the vehicle battery, if the vehicle battery is completely flat and after jump-starting the vehicle, following emergency operation, after changing the electric fuse for the slide/tilt sunroof or panorama roof or after replacing the glass panel, motor, powered sunroof mechanism or sun blind.



NOTICE

Electrically moved components

- Risk of damage to components

-> Move objects out of the range of movement.

The force limiter is not available when storing the end position so that the roof will close with full force.
1. Switch on ignition.
2. Press the actuating button forward towards Close and keep it pressed until the roof/sun blind stops moving. The process for storing the end position will start after approx. 10 seconds.
The process takes up to 20 seconds for the slide/tilt roof.

Information

When storing the end positions of the panorama roof, always save the settings for the roof and sun blind fully one after the other. If the process is interrupted, it is not possible to start the process for the other drive mechanism.

The process takes up to 45 seconds for the panorama roof/sun blind.
If you release the actuating button before the roof/sun blind has stopped moving, the process for storing the end position must be repeated.
3. Relieve the seals from strain by briefly opening and then closing the roof again.
4. Read out the fault memory using the Porsche PIWIS Tester and correct any faults that are found.