Manifold Pressure/Vacuum Sensor: Service and Repair

WM 248019 Removing and installing pressure sensor

Technical values





Preliminary work

1. Remove rear engine compartment cover at the middle. For details, see -> 700219 Removing and installing front trim (engine compartment)

Removing and installing pressure sensor

The intake pipe pressure sensor is at a central position on the intake-air distributor and is facing the plenum panel. Naturally aspirated engine -4- or Turbo engine -4-.





Intake module on naturally aspirated engine









Intake air module, Turbo





1. Remove pressure sensor.
1.1. Pull off cable plug.
1.2. Remove screw.
1.3. Remove pressure sensor by levering and turning it slightly.
2. If the sealing ring is damaged, the sensor must be replaced.
3. Fit the pressure sensor into the intake-air distributor by turning it slightly.
3.1. Position and fit the screw.
3.2. Connect cable plug.

Subsequent work

1. Fit rear engine compartment cover at the middle. For details, see -> 700219 Removing and installing front trim (engine compartment)