742319 Removing and installing backrest pocket
WM 742319 Removing and installing backrest pocket
Removing backrest pocket
Removing cover for front middle backrest
Installation position of cover for front middle backrest
1. Press cover for backrest -1- carefully out of the backrest shell -2- using a screwdriver -3-.
Loosening cover
2. Insert your hand into the top of the backrest cover -1- and disengage it by pulling it up out of the backrest frame -2- ( -arrow A- ). Then press cover for backrest together slightly in the middle -arrows B- and pull forwards and out.
Removing cover for backrest
Information
Only for vehicles with heated seats.
Information
Only for vehicles with heated seats.
3. Disconnect electric plug connection for backrest seat heating -1-.
Disconnecting plug connection
Removing backrest pocket
Installation position of backrest pocket
1. Unscrew fastening screws -1- with washers -2- on the inside.
Removing backrest pocket
2. Pull backrest pocket -3- out slightly at the top and disengage upwards.
Replacing cover for backrest pocket
Installation position of backrest pocket
1. Remove cover for backrest pocket.
Disengage cover for backrest pocket -1- out of the plastic frame -2- all the way round.
Removing cover
2. Install cover for backrest pocket.
Engage cover for backrest pocket -1- in the plastic frame -2- all the way round.
Installing cover
Installing backrest pocket
Installation position of backrest pocket
1. Engage backrest pocket -3- in the backrest shell and press in at the top.
Installing backrest pocket
2. Screw in fastening screws -1- with washers -2- on the inside onto the backrest pocket.
Installing cover for front middle backrest
Installation position of cover for front middle backrest
Information
Only for vehicles with heated seats.
Information
Only for vehicles with heated seats.
1. Connect electric plug connection for backrest seat heating -1-.
Connecting plug connection
2. Engage cover for backrest -1- in the backrest frame -2- at the top -arrow A-.
Installing cover for backrest
3. Press in cover for backrest -1- in the middle -arrows B- until the locking tabs engage -inset-.
4. Press cover for backrest -1- into the backrest shell -2- at the bottom using a plastic wedge -3-.
Securing cover