Body Equipment, Exterior
Sunroof
The electric slide/tilt roof is made of tinted single-sheet safety glass. It has a sliding roof cover that can be continuously adjusted manually to protect against the occupants from direct sunlight.
The slide/tilt roof is ready for operation:
- When the ignition is switched on
- After the ignition is switched off and before the driver's or passenger's door is first opened, but for a maximum of 10 minutes
NOTE: The slide/tilt roof features a force limiter. If obstructed during the closing process, the slide/tilt roof opens again immediately.
Emergency Operation
If the slide/tilt roof becomes inoperable, it can be closed or opened manually using the hexagon key from the tool kit. First, check that the fuse is intact before initiating emergency operation.
IMPORTANT: There is a risk of injury or damage during emergency operation. There is a risk of crushing or pinching from all moving slide/tilt roof parts. Always use the emergency operation feature with extreme care.
- Do not press the slide/tilt roof button during emergency operation.
Emergency closing after repeated intervention from the force limiter.
Remove the obstruction. Press or press-and-hold the sliding roof button repeatedly in the closing direction until the roof closes and stops in the closed position.
Storing the end position of the slide/tilt roof.
The end position of the slide/tilt roof are lost if the vehicle battery is disconnected/reconnected or dead, the vehicle is started using jumper cables, the electrical fuse for the slide/tilt roof is replaced or after emergency operation.
The vehicle must be stationary to store the end position of the slide/tilt roof.
1. Switch on ignition.
2. Press the button forwards in closing direction and hold in position. The process for storing the end position begins after approximately 10 seconds. Press and hold the button until the roof has stopped moving completely. The process takes a maximum of 20 seconds. Start the storing process again if the button is released prematurely.
WARNING: Risk of injury when closing the slide/tilt roof. When the end position is stored, the force limiter is not available and the slide/tilt roof will close with full force.