Body Emblem: Service and Repair

WM 660719 Removing and installing front logo

Technical values





Removing front logo

1. Screw off fastening nuts -3-.





Detaching logo

2. Take fastening nuts out of the opening in the front lid.
3. Remove the logo -1- and support -2- in an upward direction.





Removing logo and support

Installing front logo

Information

The fastening nuts for the logo must always be replaced.

1. Position the logo -1- and support -2-.





Fitting logo and support

2. Replace fastening nuts -3-.
3. Screw on fastening nuts -3- and tighten to the specified tightening torque => Tightening torque: 1 Nm (0.5 ftlb.)0.5 Nm (0.5 ftlb.).