II. Special Replacement Instructions For 1985-86 1.7L Engine

Installation of Heater Core Quick-Connects and Hoses





1. Install the supplied 90 degrees quick-connect on the bottom (inlet) heater core nipple and the straight quick-connect on the top (outlet) heater core nipple (Fig. 20).

2. Install the supplied rubber bulkhead seal and retainer plate over the quick-connects with the supplied screws.

3. Cut off the formed end of the existing lower heater hose.





4. Remove the clamp and short heater hose from the tee going to the radiator (Fig. 21). Install the supplied short hose on the tee with the supplied clamp. Torque the clamp to 10 in. lbs. (1 N-m).

5. Fill the heater core with coolant and install both hoses on the quick-connects as described in Section I.G.8. and continue with the procedure to reassemble interior components of the vehicle.