To Fit the Gear Lever Housing

1. Insert a screwdriver into the slot (4) and turn the switch so that the mark (2) is in line with the arrow (3).
2. Turn the ignition key to position L (locked).
3. Fit the switch with the locating pad (1) in the corresponding slot in the gear lever housing.
4. Turn the ignition switch back and forth to check that the gear lever locking mechanism does not bind or jam.
5. Fit the cover plate.
6. Fit the gear lever housing. Hook the spring onto the guide bracket (5-speed gearbox). Bolt down the bracket for the center console.
7. Connect the cables to the ignition switch and the reversing light switch.
8. Fit the ventilation air duct and fold back the carpet.
9. Fit the centre console.
10. Fit the front seat.
11. Connect the battery.





IGNITION SWITCH
1. Locating pad
2. Setting mark
3. Arrow
4. Drive slot