Front Seats - Odering Replacement Parts

CATEGORY
Microfiche Discrepancy

SECTION PAGE
14 19
ISSUE CODE
06/91 0123 852


Subject: Front Seat Replacement Assemblies

Application: 900, 9000 1986-89 and 1990- All Editions


More detailed information is now required when ordering complete front seat assemblies. All orders for ADDINFO special order seat assemblies must now contain the following information:

^ Vehicle Identification Number

^ Upholstery code

^ The type of heating pad in the seat (thermostat or Rheostat controlled)

^ Whether the seat is equipped with a magazine pocket on the back surface.

These four points of information must be included on all future orders for ADDINFO seats. Incomplete information will cause delays and increase the potential for a mis-built seat. Since special order seats are not returnable, dealers should take extra care to ensure that the proper information is provided.





FRONT SEAT REPLACEMENT ASSEMBLIES



Because of the general nature of this Microfiche Discrepancy, no specific part numbers are provided. Dealers who wish to mark their microfiche may use the information provided on the back of this bulletin to mark the appropriate grids on the editions listed.





1) Carefully align the appropriate microfiche card on the matrix.

2) Locate the desired grid location using the alpha-numeric row indicators.

^ 900 US 1986-89, Edition 12 Grid 5-E12 Position 1
Grid 5-E18 Position 1
Grid 5-F04 Position 1
Grid S-F10 Position 1

^ 900 US 1990-, Edition 6 Grid 3-C14 Position 1
Grid 3-C20 Position 1
Grid 3-D04 Position 1

^ 9000 US 1986-89, Edition 16 Grid 4-E06 Position 1
Grid 4-E16 Position 1
Grid 4-F02 Position 1

^ 9000 US 1990-, Edition 6 Grid 3-112 Position 1
Grid 3-120 Position 1


3) Using a red "El Marko" permanent pen (or similar type) mark the fiche square(s).


Note:

If you use a fine tipped pen, you can write position "1" where the error is. This will save looking up microfiche discrepancies unnecessarily.

Unless fiche are correctly marked, the microfiche discrepancy system will be of little help in your parts department. Use the system and avoid costly ordering errors.