Driver Side Air Bag Module, Replace

WARNING: Read through the Safety and handling instruction before starting work.

Removal




1. Disconnect the negative lead from the battery.

NOTE: The engine must not be running when the battery lead is disconnected. The alternator may be seriously damaged.

2. Remove the rubber plugs over the airbag retaining screws (A).
3. Remove the two airbag retaining screws (A).
4. Lift out the airbag and unplug the connector (B).

Installation
1. Fit the connector to the airbag (B).
2. Fit the airbag (A).
Tightening torque: Airbag screws 7.0 Nm (5.2 ft lb).
3. Fit the rubber plugs over the screws (A).
4. Connect the negative battery lead.
5. Connect an ISAT to the data link connector and erase any diagnostic trouble codes.

Switch on the ignition and wait for at least 10 seconds with the ignition on. Check that the SRS lamp lights for 3-4 seconds and then goes out. Check that the SRS lamp does not show a fault (stays lit).

Disconnect the ISAT