Changing the Bulb In the AC Switch Panel

To Remove
1 Unplug the Automatic Climate Control (ACC) control module.
2 Undo the six screws securing the rear part to the facia.
Undo the snap fasteners using a screwdriver.
3 Change the defective lamp.

To Install
4 Install the plastic cover so that the cable ribbon between the control module and the panel cannot be damaged.
5 Screw the panel to the control module.
6 Secure the ACC control module in the car's facia.
7 Calibrate the ACC system by pressing the "AUTO" and "VENT" buttons at the same time.

Important : During calibration, all earlier diagnostic trouble codes are erased. Before carrying out calibration, all stored diagnostic trouble codes should be read.