Speedometer Gear, M/T: Service and Repair

NOTE: Component identifier numbers used in the following illustrations relate to specific steps in the procedures below.





Removal
1. Place the differential in a screw vice with jaw protectors.
- Pull out the bearing with puller tool No. 87 92 343, or equivalent.
- Use support tool No. 87 92 210, or equivalent as a support.
2. Cut up the drive with a saw and remove it.





Installation
1. Warm up the new drive in 50° C water for about 10 minutes.
- Press the warmed-up drive on to the differential with press tool No. 87 92 236, or equivalent.
2. Press the bearing all the way down with tool 87 91 311, or equivalent.
- Use support tool as a support.