Rear Door Lock Unit

To remove







1 Remove the door trim.
2 Remove the water separator.
3 Remove the three screws holding the lock unit.
4 Detach the wire to the interior door handle.
5 Pull down the lock unit slightly to detach the pushrod.







6 Lift out the lock unit and unplug the connector.
7 Detach the wires for the door handle and locking rod from the lock unit.


To fit






1 Attach the wire for the door handle and the locking rod to the lock unit
2 Plug in the connector.
3 Fit the lock unit and insert the pushrod between the exterior door handle and the lock unit.
4 Attach the wire for the interior door handle.
5 Screw on the lock unit.







6 Refit the water separator, door trim and cover around the window frame.