With Manufacturer's Scan Tool
Clear Memory ModeOPERATION
1. SUBARU SELECT MONITOR (NORMAL MODE)
1. On the Main Menu display screen, select the {2. Each System Check} and press the [YES] key.
2. On the System Selection Menu display screen, select the {Engine Control System} and press the [YES] key.
3. Press the [YES] key after the information of engine type is displayed.
4. On the Engine Diagnosis display screen, select the {Clear Memory} and press the [YES] key.
5. When the "Done" and "Turn Ignition Switch OFF" are shown on the display screen, turn the ignition switch to OFF, and then turn the Subaru Select Monitor power switch to OFF.
NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
2. SUBARU SELECT MONITOR (OBD MODE)
1. On the Main Menu display screen, select the {2. Each System Check} and press the [YES] key.
2. On the System Selection Menu display screen, select the {Engine Control System} and press the [YES] key.
3. Press the [YES] key after the information of engine type is displayed.
4. On the Engine Diagnosis display screen, select the {OBD System} and press the [YES] key.
5. On the OBD Menu display screen, select the {4. Diagnosis Code(s) Cleared} and press the [YES] key.
6. When the "Clear Diagnostic Code?" is shown on the display screen, press the [YES] key.
7. Turn the ignition switch to OFF, and then turn the Subaru Select Monitor power switch to OFF.
NOTE: For detailed operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.