Procedure, RHD
Procedure, RHD1. Remove the scuff plate (A) and the lower cover (B) on the right-hand side.
2. Remove the sound insulation panel on the driver's side, see WIS - 8. Body - Interior equipment - Adjustment/Replacement.
3. Remove the main instrument unit, see WIS - 3. Electrical system - Driver Information, main instrument unit and SID - Adjustment/Replacement.
4. Route the new wiring harness up between the audio/navigation unit and H33-4 along the existing panel harness, out on the right-hand side of the panel where the wiring harness is routed in front of the steering wheel member (A). The wiring harness must be routed under the wiring harness for the temperature sensor (B) in the air duct.
5. Unplug the connector H33-4 (A) and expose the wiring harness by cutting the cable tie (B) to the clip.
6. Replace the wiring harness in connector H33-4. Make sure that the new pins are in the correct position:
- Extract the connections 20 - 28 in connector H33-4.
- Cut off the pins, fold the cables back and tape them together with the wiring harness.
- Connect wiring harness (12783014) to H33-4. Connect in accordance with the following:
Yellow -> 20
Black/yellow -> 21
Blue -> 22
Brown/blue -> 23
Brown/white -> 24
Black/blue -> 25
Black/green -> 26
Brown -> 27
Black -> 28
7. Secure the wiring harness at the right-hand A-pillar together with the normal wiring harness between the audio/navigation unit and H33-4.
- Secure with cable ties to the clip (A).
- Secure with cable ties to the duct outlet (B).
- Secure with cable ties to the steering wheel member (C).
8. Secure the wiring harness in the instrument panel together with the normal wiring harness between the audio/navigation unit and H33-4.
- Secure with cable ties to the normal cable harness (A).
- Remove the tape (B) on the protective hoses and route the wiring harness through the hoses (B). Check that the correct cables are routed through the relevant hose.
9. Replace the wiring harness to the audio/navigation unit. Make sure that the new pins are in the correct position:
- Remove the secondary catch in connectors K14 and K16.
- Extract the connections 2, 3, 9, 10, 11 in connector K14.
- Extract the connections 5, 6, 13, 14 in connector K16.
- Cut off the pins, fold the cables back and tape them together with the wiring harness.
- Connect wiring harness (12783014) to K14. Connect in accordance with the following:
Blue -> 2
Yellow -> 3
Brown/blue -> 9
Black/yellow -> 10
Black -> 11
- Connect wiring harness (12783014) to K16. Connect in accordance with the following:
Black/green -> 5
Brown/white -> 6
Brown -> 13
Black/blue -> 14
- Fit the secondary catch in connectors K14 and K16.
10. Tape around the ends of the protective hoses (A).
11. Plug in connector H33-4.
12. Fit the sound insulation panel on the driver's side, see WIS - 8. Body - Interior equipment - Adjustment/Replacement.
13. Fit the scuff plate (A) and the lower cover (B) on the right-hand side.
14. Fit the main instrument unit, see WIS - 3. Electrical system - Driver Information, main instrument unit and SID - Adjustment/Replacement.