Engine Mounting, Right

Engine mounting, right

To remove
1. Raise the car.
2. CV:Remove Chassis reinforcement, front subframe, CV.
3. Fit 83 96 145 centering fixture, subframe - engine on the engine's subframe and 83 96 152 centering tool, power train with 32 025 059 Support. First remove the two long supports. Relieve the load from the engine.





4. Lower the car.

Important
When removing the air cleaner casing cover, be careful not to damage the brake vacuum pump sensor.

5. Remove the upper section of the air cleaner.





6. Remove the lower section of the air filter.





7. Remove the engine pad.





8. Remove the power steering pipe clip from the engine mounting.





9. Remove the engine mounting from the engine (some models do not have a lower bolt).

Note
The hole of the lower bolt is slotted.

To fit
1. Fit the engine mounting to the engine (some models do not have a lower bolt).
Tightening torque 93 Nm (69 lbf ft)





2. Fit the power steering pipe clip to the engine mounting.
3. Fit the engine pad.
Tightening torque to body: 50 Nm + 180 degrees (37 lbf ft + 180 degrees)
Tightening torque to engine mounting: 45 Nm + 90 degrees (33 lbf ft + 90 degrees)





4. Fit the lower section of the air cleaner.





5. Fit the upper section of the air cleaner.





6. Raise the car.
7. Remove centering fixture.
8. CV:Fit Chassis reinforcement.
9. Lower the car.