Headlamp: Testing and Inspection

Headlamps, Programming

Programming, headlamps
The vehicle can be programmed for three different types of headlamp logic:

IMPORTANT:
^ Switching between main and dipped beams is only possible with the light switch in position 2. Applies to all alternatives.
^ Fuse 35 has been removed from cars on markets where daytime running lights are not used. Program alternatives 1 and 2.
^ While the engine is being started, dipped beam is turned off. This is irrespective of the program alternative if the light switch is in position 0 or 1, but for safety reasons it is maximized to 20 seconds.

Alternative 1
When the light switch (10) is in position 0 or 1, none of the main lighting should be active.

In position 0, none of the parking lights should be active. (Germany + other markets).

Alternative 2
When the light switch is in position 0, dipped beams should be on (daytime running lights).

In position 0 it is not possible to switch between main and dipped beams (Sweden).

Alternative 3
When the light switch is in position 0 or 1, the dipped beams should be on.

In position 0 or 1 it is not possible to switch between main and dipped beams (Canada).

Programming, parking lights
Acoustic warning (yes/no)

Pre-programmed: yes