Fuel Filter: Service and Repair

Fuel filter

WARNING: Removal of the fuel filter involves partial dismantling of the car's fuel system. The following points must therefore be observed in connection with this work:
- Work only in a well-ventilated area. If approved equipment for the extraction of fuel vapours is available, be sure to use it.
- Wear suitable gloves. Prolonged contact with fuel can cause skin irritation or dermatitis.
- Keep a class BE fire extinguisher near at hand. Be mindful of the danger of sparks caused by short circuits and when connecting and disconnecting leads in electrical circuits.
- No smoking anywhere in the vicinity,
- Wear protective goggles.





To Remove

1 Drain all fuel from the filter before removing it. Place a suitable receptacle under the filter to collect the fuel.





2 Undo the banjo fittings on both sides of the filter.
3 Undo the fitter clamp.





4 Remove the filter.

To fit
Fit in reverse order.
Tightening torque, banjo fittings: 21 Nm (16 lbf ft)

Important
Inspect the sealing washers before fitting and change them as necessary.