Yaw Rate Sensor: Service and Repair
Yaw rate sensorTo remove
1. Remove the center console.
2. Manual gearbox: Remove the gear lever housing.
Automatic transmission: Remove the selector lever housing.
3. Remove the gyro sensor. Use a large screwdriver to pry aside the air duct slightly to access the left-hand screw.
4. Unplug the connector from the gyro sensor.
Note
The connector has a locking device that must be released.
To fit
1. Plug in the gyro sensor.
2. Fit the gyro sensor to the bracket. Use a large screwdriver to pry aside the air duct slightly to access the left-hand screw.
Important
Fit the gyro sensor with the connector and arrow pointing forward in the car.
Tightening torque up to and including Vehicle Identification Number 73514907: 10 Nm (7 lbf ft)
Tightening torque from and including Vehicle Identification Number 73514908: 8 Nm (6 lbf ft)
3. Manual gearbox: Fit the gear lever housing.
Automatic transmission: Fit the selector lever housing.
4. Fit the center console.