Automatic Transmission, Transmission Fluid Level Without Dipstick

Automatic transmission, transmission fluid level without dipstick

Warning
Hold the foot brake depressed.

1. Park the car on level ground and apply the hand brake.
2. Start the engine and allow it to idle. Select position D and wait for at least 15 seconds. Then select R and wait for 15 seconds. Repeat for position P.
3. Connect the diagnostic tool and run the engine until it reaches 80 degrees C as per the "Read values" menu for TCM.

Warning
Risk or burn injuries when working on the catalytic converter.

4. Remove the plug using 30 16 516 Torx sleeve. Use butyl tape or the like to secure the plug on the tool.





5. Check the fluid level using DT-47653 Gauge rod. (engine idling and selector lever in P). Fill with fluid as necessary using 87 92 822 Oil filling equipment. Pay attention to the appearance and odor of the fluid. If the fluid is cloudy/discolored and/or smells burnt it must be changed even if there is no noticeable reduction in shift quality or noise. See Changing the automatic transmission fluid.





Important
Fill up with oil through the dipstick hole. Do not remove any other plugs from the top of the gearbox.

Important
The dipstick has only one measuring range for warm oil. The oil volume between min-max is 0.5 liters (0.5 qts).

6. Fit the plug

Tightening torque 30 Nm (22 lbf ft)