O-Ring and Sealing Ring In Seal Retainer, Left-Hand
O-ring and sealing ring in seal retainer, left-handTo remove
Removed gearbox
1. Undo the five bolts on the seal retainer and remove the seal retainer. Keep shims, bolts and the seal retainer in a safe place.
2. Press out the sealing ring using 87 91 311 Sleeve, driver shaft bearing and support 87 92 2364 ->.
3. Detach the O-ring with a small screwdriver or similar.
To fit
1. Press on the seal ring with drift 87 92 657 -> until it stops. Use tool 87 92 236 -> as support.
2. Lubricate a new O-ring and carefully fit it.
3. Fit the seal retainer and shims with the bolts. Tighten alternately.
Tightening torque 22 Nm (16 lbf ft)