Driver or Passenger Seat Cushion Frame Replacement
Driver or Passenger Seat Cushion Frame Replacement
Removal Procedure
1. Remove the 3 seat switch bezel mounting screws. Refer to Driver or Passenger Seat Adjuster Switch Bezel Replacement (Driver or Passenger Seat Adjuster Switch Bezel Replacement).
2. Remove the 4 nuts that secure the seat pan to the power seat adjuster frame.
3. Remove the clip from the front outboard seat pan stud , if equipped. Discard the clip.
4. Disconnect the black electrical connector (6) from the seat back harness.
5. Disconnect the black electrical connector (3) from the seat belt buckle.
6. Disconnect the gray lumbar electrical connector (5), if equipped.
7. Remove the SIR harness (2) from the harness clips (1, 4), and remove the SIR harness from the seat.
8. Remove the seat harness from the seat pan.
9. Remove the seat memory module, if equipped. Refer to Memory Seat Control Module Replacement (Service and Repair).
10. Remove the seat cushion assembly.
11. Remove the seat cushion cover and pad from the seat frame. Refer to Front Seat Cushion Cover and Pad Replacement (Front Seat Cushion Cover and Pad Replacement).
12. Remove the wiring harness and connector clips, if you are replacing the frame.
Installation Procedure
1. Install the wiring harness and connector clips, if you replaced the frame.
2. Install the seat memory module, if equipped. Refer to Memory Seat Control Module Replacement (Service and Repair).
3. Install the seat cushion cover and pad to the seat frame. Refer to Front Seat Cushion Cover and Pad Replacement (Front Seat Cushion Cover and Pad Replacement).
Caution: Refer to Fastener Caution (Fastener Caution).
4. Install the 4 nuts that secure the seat pan to the power seat adjuster frame and tighten to 25 Nm (18 ft. lbs.)
5. Install the seat harness to the seat pan.
6. Install the SIR harness (2) to the seat clips (1, 4).
7. Connect the gray lumbar electrical connector (5), if equipped.
8. Connect the black electrical connector (3) to the seat belt buckle.
9. Connect the black electrical connector (6) to the seat back harness.
10. Install the 3 seat switch bezel mounting screws. Refer to Driver or Passenger Seat Adjuster Switch Bezel Replacement (Driver or Passenger Seat Adjuster Switch Bezel Replacement).