Rear Seat Replacement

Rear Seat Replacement

Removal Procedure

1. Remove the communication interface module if removing the right-hand rear seat. Refer to Communication Interface Module Replacement (Service and Repair).




2. Remove the front 2 rear seat mounting nuts (2) securing the seat to the vehicle.
3. Fold the seat to the stowed position.
4. Remove the rear 2 rear seat mounting nuts (2) securing the seat to the vehicle.
5. Remove the seat from the vehicle.

Installation Procedure




1. Position the seat onto the floor studs. The seat should be in the folded position.
2. Install the 2 rear nuts (2). Do not tighten the nuts.
3. Unfold the seat to ensure that the seat latch (1) properly engages the latch bar (3) on the floor.

Caution: Refer to Fastener Caution (Fastener Caution).

4. Install the front 2 rear seat mounting nuts (2) and tighten to 45 Nm (33 ft. lbs.).
5. Fold the seat to the stowed position.
6. Tighten the 2 rear seat mounting nuts (2) to 45 Nm (33 ft. lbs.).
7. Install the communication interface module if installing the right-hand rear seat. Refer to Communication Interface Module Replacement (Service and Repair).