Engine Front Cover Installation

Engine Front Cover Installation

Special Tools

J 44219 - Engine Cover Alignment Pins





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the engine front cover spacer bolt. Tighten the engine front cover spacer bolt to 10 Nm (89 in. lbs.).
2. Install the crankshaft balancer friction washer GM P/N 12573950 over the crankshaft snout, up against the crankshaft gear.




3. Install J 44219 - pins.





Note: The engine front cover must be installed within 10 minutes from when the sealer was applied.

4. Apply a 3 mm (0.12 in) bead of sealer GM P/N 12378521, Canadian P/N 88901148 to the back side of the engine front cover (1).




5. Align the oil pump to the crankshaft sprocket splines.
6. Install the engine front cover.
7. Remove J 44219 - pins.
8. Install the engine front cover bolts.

1. Tighten the engine front cover bolts to 10 Nm (89 in. lbs.).
2. Tighten the small center bolt (1) last to 10 Nm (89 in. lbs.).