B0540
DTC B0540
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using the diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC B0540
- Speedometer Circuit
Diagnostic Fault Information
Circuit Description
The engine control module (ECM) creates the vehicle speed signal by pulsing the vehicle speed signal circuit to ground at a rate of 4KPPM. The instrument panel cluster (IPC) converts the 4KPPM vehicle speed signal to a speedometer position to indicate the vehicle speed. The IPC also receives from the ECM a serial data message indicating the vehicle speed. The IPC uses the serial data vehicle speed information from the ECM for diagnostics purposes.
Conditions for Running the DTC
* The IPC receives a serial data message from the ECM indicating that the vehicle speed is greater than 10 km/h (6 mph).
* The ignition voltage is between 9-18 volts.
Conditions for Setting the DTC
* The IPC detects that the vehicle speed signal circuit does not match the vehicle speed from the serial data circuit.
* The condition above must be present for a minimum of 5 seconds.
Action Taken When the DTC Sets
* The IPC stores a DTC B0540 in memory.
* The speedometer defaults to 0 km/h (0 mph).
Conditions for Clearing the DTC
* The DTC becomes history when the conditions for setting the DTC are no longer present.
* The history DTC clears after 40 malfunction-free warm-up cycles.
Reference Information
Schematic Reference
Instrument Cluster Schematics (Instrument Cluster Schematics)
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
Instrument Cluster Description and Operation (Description and Operation)
Electrical Information Reference
* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)
Scan Tool Reference
Control Module References (Programming and Relearning) for scan tool information
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector X1 at the ECM. Install a signal generator and instrument panel tester between the vehicle speed signal circuit terminal 39 and ground.
2. Ignition ON, set the signal generator to generate a speedometer signal. Verify that the vehicle speedometer indicates a reading.
• If no speedometer reading is present, test the signal circuit for a short to voltage, a short to ground or an open/high resistance. If the circuit tests normal, replace the IPC.
3. Ignition OFF, disconnect the harness connector at the transmission control module (TCM).
4. Ignition ON, test for 9 - 13 volts between the vehicle speed signal circuit terminal 5 and ground.
• If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
• If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal replace the ECM.
5. If all circuits test normal, test or replace the TCM.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
Control Module References (Programming and Relearning) for the ECM, TCM and IPC replacement, setup, and programming.