Operation CHARM: Car repair manuals for everyone.

B1516




DTC B1516

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

DTC Descriptors
DTC B1516
- Battery Current Sensor Performance

Circuit/System Description

The generator battery control module (GBCM) monitors its internal battery current sensor for many charging system operations. If the value of the battery current sensor is out of range, DTC B1516 will set.

Conditions for Running the DTC

The engine is running.

Conditions for Setting the DTC

The duty cycle of the internal battery current sensor is less than 2 percent duty cycle or greater than 98 percent duty cycle for greater than 240 seconds.

Action Taken When the DTC Sets

The regulated voltage control (RVC) is disabled.

Conditions for Clearing the DTC

The duty cycle of the internal battery current sensor is 3-97 percent duty cycle.

Reference Information
Schematic Reference

Starting and Charging Schematics ([1][2]Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Charging System Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Verification

Replace the GBCM.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning) for GBCM replacement, setup, and programming.