B3031
DTC B3031
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides and overview of each diagnostic category.
DTC Descriptor
DTC B3031
- Security System Controller In Learn Mode
Circuit/System Description
When learning a vehicle key, the theft deterrent module (TDM) is placed in learn mode. DTC B3031 will set automatically as an indicator that the system is in learn mode and not as a fault indicator. Once the coded key is learned, learn mode will be exited and the DTC cleared. If the TDM does not exit learn mode, B3031 will remain current and indicate a fault.
Conditions for Running the DTC
The immobilizer system is in learn mode.
Conditions for Setting the DTC
DTC B3031 will set any time the TDM enters learn mode.
Action Taken When the DTC Sets
The security indicator will illuminate.
Conditions for Clearing the DTC
* A current DTC will be cleared upon the successful exit of learn mode.
* A history DTC will be cleared after 100 malfunction-free ignition cycles.
Reference Information
Schematic Reference
Immobilizer Schematics (Immobilizer Schematics)
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
Immobilizer Description and Operation (Immobilizer Description and Operation)
Electrical Information Reference
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Circuit Testing (Circuit Testing)
* Wiring Repairs (Wiring Repairs)
* Connector Repairs (Connector Repairs)
Scan Tool Reference
Control Module References (Programming and Relearning) for scan tool information
Circuit/System Verification
Important: When performing a 10 Minute Relearn Procedure, all keys not learned at that time will be erased and not be recognized. Perform the Adding Keys procedure on all keys or instruct the customer how to perform the Adding Keys procedure should all vehicle keys not be present at the time of repair.
1. Verify DTC B3055 is not set as current.
• If DTC B3055 is set as current, refer to DTC B2947, B2948, B2955, B2960, or B3055 (B2947).
2. Perform the 10 Minute Vehicle Key Relearn procedure. Refer to Replacing Keys (North America except Canada) (Replacing Keys (North America except Canada))Replacing Keys (Canada) (Replacing Keys (Canada)). The TDM should exit learn mode and DTC B3031 should clear.
• If the TDM does not exit learn mode, replace the TDM.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
Control Module References (Programming and Relearning) for TDM replacement, setup, and programming