C0131
DTC C0131
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions)provides an overview of each diagnostic category.
DTC Descriptor
DTC C0131 00
- ABS Pressure Circuit No Additional Information
Circuit/System Description
The electronic brake control module (EBCM) uses input from the brake pressure sensor for more accurate control during a Vehicle Stability Enhancement System (VSES) event.
Conditions for Running the DTC
* The ignition is ON.
* Ignition voltage is greater than 8 volts.
Conditions for Setting the DTC
* Brake signal does not correlate to pressure signal.
* Signal is erratic and changes faster than physically allowed.
Action Taken When the DTC Sets
* The Traction Control indicator turns ON.
* The driver information center (DIC) displays the Service Stability System message.
Conditions for Clearing the DTC
* The condition for setting the DTC is no longer present and the DTC is cleared with a scan tool.
* The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.
Reference Information
Schematic Reference
Antilock Brake System Schematics ([1][2]Antilock Brakes / Traction Control Systems)
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
ABS Description and Operation (Description and Operation)
Electrical Information Reference
* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)
Scan Tool Reference
Control Module References (Programming and Relearning)for EBCM
Circuit/System Testing
1. Apply and release brake pedal. Verify brake lamps operate properly.
• If brake lamps do not operate properly, refer to Symptoms - Lighting (Symptoms - Lighting).
2. Replace EBCM/brake pressure modulator valve (BPMV) assembly.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
Brake Pressure Modulator Valve Replacement (Brake Pressure Modulator Valve Replacement)for BPMV assembly replacement, setup, and programming.