C0327

DTC C0327

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Diagnostic System Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Strategy Based Diagnosis) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Diagnostic Procedure Instructions) provides an overview of each diagnostic category.

DTC Descriptor
DTC C0327
- Encoder Circuit Malfunction

Circuit/System Description

The transfer case encoder is an analog sensor that returns a signal that represents the physical position of the transfer case sector shaft. The signal represents the mode or position that the transfer case is currently in.

This sensor is made up of the following 3 circuits:

* A 5-volt reference circuit
* An encoder signal circuit
* An encoder low reference circuit

This DTC detects an out of range reading from the encoder signal or a short to voltage on the 5-volt reference circuit.

Conditions for Setting the DTC

The transfer case shift control module has a predefined range in which the encoder feed back should stay within, 0.5-4.5 volts. The DTC sets if the encoder signal feed back falls out of this range.

Action Taken When the DTC Sets

* All motor activity stops.
* The SERVICE AWD indicator remains illuminated for the remainder of the current ignition cycle.

Conditions for Clearing the DTC

* The transfer case shift control module clears the DTC if the condition for setting the DTC no longer exists.
* A history DTC clears after 100 consecutive ignition cycles without a fault present.
* History DTCs can be cleared using a scan tool.

Diagnostic Aid

Check the mechanical condition of the shift lever detent shaft connected to the motor. If this shaft has too much mechanical play this can cause an under voltage or over voltage from the encoder causing the DTC to set.

Reference Information
Schematic Reference

Transfer Case Control Schematics (Electrical Diagrams)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Transfer Case Description and Operation (NVG 126-NP4 - Transfer Case)
Electrical Information Reference

* Circuit Testing (Circuit Testing)
* Connector Repairs (Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (Wiring Repairs)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.