Rear Seat Number 1 Head Restraint Retractor Assembly Replacement

Rear Seat Number 1 Head Restraint Retractor Assembly Replacement

Removal Procedure

Warning: Refer to Prevent Accidental Deployment of the Head Restraint Retractor Assembly Warning (Prevent Accidental Deployment of the Head Restraint Retractor Assembly Warning).

1. Remove the seat back cover and pad. Refer to Rear Seat Back Cushion Cover and Pad Replacement (Rear Seat Back Cushion Cover and Pad Replacement).




2. Remove the 3 bolts that retain the head restraint retractor assembly to the seat back frame.




3. Partially remove the head restraint retractor assembly from the frame.




4. Remove the release cable by sliding the cable retainer over to the large access hole and removing the cable from the head restraint retractor assembly.
5. Remove the retractor assembly from the seat back frame.

Installation Procedure




1. Position the head restraint retractor assembly to the seat back.




2. Install the release cable through the head restraint retractor assembly access hole and sliding the cable retainer into position.

Caution: Refer to Fastener Caution (Fastener Caution).




3. Install the 3 bolts that retain the head restraint retractor assembly to the seat back frame and tighten to 10 Nm (88 in. lbs.).
4. Install the seat back cover and pad. Refer to Rear Seat Back Cushion Cover and Pad Replacement (Rear Seat Back Cushion Cover and Pad Replacement).