Instrument Cluster / Carrier: Service and Repair

Instrument Cluster Replacement

Removal Procedure

1. Remove the left closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side (Instrument Panel Insulator Panel Replacement - Left Side).
2. Remove the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement (Driver Knee Bolster Panel Replacement).
3. Remove the instrument panel cluster (IPC) bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement (Instrument Panel Cluster Trim Plate Bezel Replacement).




4. Remove the screws retaining the IPC to the I/P.
5. Partially remove the IPC from the I/P in order to gain access to the electrical connector.
6. Disconnect the electrical connector from the IPC.
7. Remove the IPC from the I/P.

Installation Procedure




1. Position the IPC to the I/P.
2. Connect the electrical connector to the IPC.
3. Install the IPC to the I/P.

Caution: Refer to Fastener Caution (Fastener Caution).

4. Install the screws to the instrument panel cluster and tighten to 2.5 Nm (22 in. lbs.).
5. Install the IPC bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement (Instrument Panel Cluster Trim Plate Bezel Replacement).
6. Install the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement (Driver Knee Bolster Panel Replacement).
7. Install the left closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side (Instrument Panel Insulator Panel Replacement - Left Side).
8. If installing a new IPC, program the IPC. Refer to Control Module References (Programming and Relearning).