Ignition Cable: Service and Repair

Spark Plug Wire Replacement

Removal Procedure




1. Remove the spark plug wire. Refer to Spark Plug Wire Replacement .
2. Remove the washer solvent container to gain access to the #2 spark plug. Refer to Windshield Washer Solvent Container Replacement (Service and Repair).
3. Loosen the spark plug 1-2 turns.
4. Brush or using compressed air, blow away any dirt from around the spark plug.
5. Remove the spark plug.
If removing more than one plug, place each plug in a tray marked with the corresponding cylinder number.

Installation Procedure




1. Correctly position the spark plug washer.
2. Inspect the spark plug gap. Adjust the gap as needed.

Spark plug gap: 1.524 mm (0.060 in)

3. Hand start the spark plug in the corresponding cylinder.

Caution: Refer to Fastener Caution (Fastener Caution).

4. Tighten the spark plug.

* For used heads, tighten the plug to 15 Nm (11 ft. lbs.).
* For NEW heads, tighten the plug to 20 Nm (15 ft. lbs.).

5. Install the spark plug wire. Refer to Spark Plug Wire Replacement .
6. If removed, install the washer solvent container. Refer to Windshield Washer Solvent Container Replacement (Service and Repair).