Rear Seat Backrest, 5D

Rear Seat Backrest, 5D

To remove

The 40% part of the backrest can be removed separately. The 40% part must first be removed to remove the 60% part.

1. Remove the rear seat cushion.
2. If the 60% backrest is to be removed: Remove the centre belt lower anchorage.






3. Tip forward the rear backrest.
4. Lift up the outer edge of the 40% backrest from its mounting.






NOTE: Take care with the side bolster. Press in the upholstery fabric while lifting up the backrest.

5. Angle the 40% backrest upwards/forwards so that it releases from the guide pin at the centre mounting and take out the backrest.






6. Lift up the outer edge of the 60% backrest from its mounting.






NOTE: Take care with the side bolster. Press in the upholstery fabric while lifting up the backrest.


7. Angle the 60% backrest upwards/forwards so that it releases from the guide pin at the centre mounting and take out the backrest.

To fit

1. Insert the locating pin on the 60% section into the centre mounting.






2. Fit the outer edge of the 60% backrest to its mounting and fold up the backrest.
3. Fit the belt centre anchorage and seat belt buckle.






NOTE:
- The seatbelt strap must not be twisted.
- Make sure the lock guide tongue is located in the recess in the floor.

Tightening torque 45 Nm (33 lbf ft)

4. Fit the 40% section of the backrest by fitting the lower inner part of the backrest over the locating pin.






5. Fit the outer edge of the 40% section into its mounting.






6. Make sure the backrest locks securely.
7. Fit the rear seat cushion.