C0406

DTC C0406

Diagnostic Instructions

- Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
- Review Strategy Based Diagnosis for an overview of the diagnostic approach.
- Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC C0406 0B

Transfer Case Solenoid Valve Control Circuit High Current

Diagnostic Fault Information





Circuit/System Description

The rear drive clutch solenoid valve is internal to the torque transfer device housing. The rear differential clutch control module supplies battery voltage to the control circuit and ground to the low reference circuit of the solenoid valve. The solenoid valve is controlled by a pulse width modulation (PWM) signal. The solenoid valve controls the hydraulic pressure to the clutch package of the torque transfer device. The locking level of the torque transfer device depends on the engagement of the clutch package.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

- The rear differential clutch control module detects a short to ground on the control circuit of the rear drive clutch solenoid valve.
- The rear differential clutch control module detects a current more than 11 A on the control circuit of the rear drive clutch solenoid valve.

Action Taken When the DTC Sets

One or more of the following actions may occur:
- All-wheel drive (AWD) is disabled.
- Service Rear Axle is displayed on the driver information center.

Conditions for Clearing the DTC

- The condition for setting the DTC is no longer present.
- The DTC is not detected in 40 consecutive ignition cycles.

Reference Information

Schematic Reference

Rear Axle Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Rear Drive Axle Description and Operation

Electrical Information Reference

- Circuit Testing
- Connector Repairs
- Testing for Intermittent Conditions and Poor Connections
- Wiring Repairs

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

Engine running, observe the scan tool Rear Drive Clutch Status parameter. The scan tool should display TEMPORARILY LIMITED when stationary.

Circuit/System Testing

Note
The rear drive clutch solenoid valve is calibrated with and is part of the rear differential clutch control module. Both components must be replaced as a matched set.

Verify DTC C0406 is not set.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for rear differential clutch control module replacement, setup, and programming