Cylinder Head Installation

Cylinder Head Installation (LDK, LHU)

Special Tools

EN-45059 Angle Meter

1. Note
Do not use any sealing material.

Install the cylinder head gasket (2) to the block.





2. Install the cylinder head (1). Ensure the number 1 cylinder is at top dead center (TDC). The key on the crankshaft should be on top in the 12 o'clock position.
3. Refer to Fastener Caution.

Note
Always use NEW cylinder head fastener.

Install NEW cylinder head bolts.





3.1. Tighten the bolts in sequence to 30 Nm (22 lb ft).
3.2. Tighten the bolts an additional 155 degrees in sequence using the EN-45059 angle meter.
4. Install the front cylinder head bolts (1) and tighten to 35 Nm (26 lb ft).