Balance Shaft Installation
Balance Shaft InstallationSpecial Tools
EN-43650 Balance Shaft Bushing Remover/Installer
1. Install the balance shaft bushing (2) using the EN-43650 remover/installer (1).
2. Seat the balance shaft bushing into the bore using the EN-43650 remover/installer (1) and a wrench.
3. When the EN-43650 remover/installer is fully seated in the engine block, remove it with a wrench.
4. Note
If the balance shafts are not properly timed to the engine, the engine may vibrate or make noise.
Place the number one piston at top dead center (TDC).
5. Lubricate the balance shaft lobes with engine oil.
6. Install the balance shafts (1) into their bores.
7. Refer to Fastener Caution.
Install the balancer shaft bolts and tighten to 10 Nm (89 lb in).